The so-called emergency repairs. It refers to the failure of the right to procrastinate during operation of the farmland or during transportation, and no replacement of spare parts, and emergency measures taken by the west repair station. â— Emergency Repair of Burning Cylinder Mats During driving, if the cylinder mat is burnt out with a small hole, use the asbestos thread or hard foil inside the cigarette box to fill in the burned parts. If the burned area is large, you can cut a patch from the same part of the waste cylinder gasket to the burned area, or cut a piece of cowhide with the same shape as the burned part (thickness should be consistent with the liner) and put it in the burned part. Then tap it with a hammer to make it bind tightly. â— chaos easy to remove the law of the gear rod ball joints and spherical wear, resulting in the bottom of the shift lever inserted into the depth of the slot is not enough, when the file file is slipped. At this time, the shift lever seat can be removed, and the waste inner tube can be used to cut 1-2 spacers, and the gap between the shift lever ball joint and the spherical upper cover can be eliminated. â— Hand-shifting automatic steering Simple removal method Hand-pulling machine Steering gear meshes with the central transmission gear due to the spring force of the steering spring. With the use of a long time, the elastic force of the spring will weaken, easy to make the steering gear from the central transmission gear, automatic steering failure occurs. Remedy: Adding a suitable spacer between the steering spring and the bearing can achieve the purpose of increasing the elastic force of the spring, and the automatic steering can be eliminated. â— Simple method of oil leakage from the fuel tank. Oil spill from the fuel tank is found during the journey. Clean the leak and apply soap or bubble gum to the leak to reduce leakage. If there is any adhesive such as epoxy resin glue, use a temporary blocking Leakage, better results. â— Repair of oil leakage from high-pressure fuel pipe The projections at both ends of the high-pressure fuel pipe are connected with the concave surfaces of the fuel injector and the oil valve tight seat, and there is no gasket in the middle without oil leakage. If the contact surface wears, it will leak oil. At this time, a circular copper skin can be cut from the waste cylinder pad, a small hole is placed in the middle, and the nut is tightened between the convex head and the concave head. The oil spill problem is solved.