![]()
**How to Warm Up Your Greenhouse Using the Gargle Starter**
If you're looking to prepare your greenhouse for planting, using a warming agent is an effective and eco-friendly approach. This method helps raise the soil temperature naturally, creating a better environment for your plants to grow. Here's a step-by-step guide on how to do it:
**1. Preparation**
Before starting, make sure the site is ready. Clear the area of any debris, such as rocks or old plants. Two weeks before planting, apply 60-70% of the recommended compound and chemical fertilizers to the soil. Also, prepare the beds by digging trenches that are 40–60 cm wide and 20–30 cm deep. The ridge width depends on whether you're using a single or double-row system: 80–100 cm for single rows, and 130–150 cm for double rows.
**2. Amount of Warming Agent**
For each acre, use approximately 4 kg of the warming agent. In a typical 50m x 8m greenhouse, about 3 kg will suffice. You can calculate based on the area or the weight of straw used. For every kilogram of straw, add one kilogram of the warming agent.
**3. Straw and Manure Dosage**
Use 3,000–5,000 kg of straw (such as corn stalks) per acre. Mix in 3–6 cubic meters of manure from herbivorous animals like cows, horses, or sheep. This combination helps speed up the fermentation process and improves soil fertility.
**4. Timing**
Begin this process 15–20 days before planting. This gives the materials enough time to ferment and generate heat.
**5. Bacteria Application Method**
Mix 1 kg of the warming agent with 10 kg of wheat bran or rice bran, then add 6–8 kg of water. The mixture should be moist but not soggy—when squeezed, it should hold a few drops of water. Let it sit for 12–24 hours at a temperature between 15–25°C before applying.
**6. Single-Row Operation**
In the single-row method, create ridges that are 80–100 cm wide, with a 40–60 cm ditch in the middle. Fill the ditch with straw, making sure it’s at least 30 cm thick, and compact it. Leave 10–15 cm of straw exposed at both ends for ventilation. Spread the fermented bacteria evenly over the straw, mix it in, and let it settle. You can also layer the straw with the bacterial mixture and manure for better results. Cover the straw with 15–20 cm of soil and form a small high ridge. Ensure the walkway is slightly raised for easier access and watering.
**7. Double-Row Operation**
For a double-row setup, the total width is 130–150 cm, with 60–80 cm gaps between the rows. Dig trenches 20–30 cm deep and fill them with straw. Build a sorghum-like bed 60–80 cm wide and 15–20 cm high, where you’ll later plant your seedlings.
**8. Covering and Watering**
After filling the trench, cover the entire area with straw, ensuring no part is left exposed. Keep the straw 10–15 cm above the surface for proper air circulation. Water the straw 10–15 days before planting to keep it moist and promote fermentation.
**9. Ventilation After Planting**
Once the plants are in place, poke holes in the plastic covering using a 3 cm tip or a steel drill. Space the holes 10–15 cm apart and ensure they go through the straw layer. This allows for proper airflow and carbon dioxide release, which is essential for healthy plant growth.
By following these steps, you'll create a warm, fertile environment in your greenhouse that supports strong plant development. It's a natural, cost-effective way to improve your growing conditions and get your crops off to a great start.
Ammonium Acetate
Ammonium Acetate,Acetate Ammonium,Acetic Acid Ammonium Salt,Ammonium Ethanoate
Wuxi Yangshan Biochemical Co.,Ltd. , https://www.yangshanchem.com