Boar: Feed 2 times a day, add green feed or thinner at noon. Breeding and exercise are carried out in the morning and evening. Do not take a bath or spray cold water immediately after breeding. Every day from 1 pm to 3 pm, the pig body and the ground are sprayed once, and the light is reduced to 8-10 hours. If the number of breeding is small, the amount of concentrate should be reduced to prevent excessive fat and poor sexual desire.
Pregnancy sows: Pregnancy sows should be dominated by green and coarse materials, with appropriate concentrates, reducing stocking density, and raising 2-3 heads per turn. In the late pregnancy and lactation, one pig is lap, and the concentrate is mainly used to match the green material. The coarse material can not be fed. Feed 3 times a day, add thinner in the middle, spray water once. Add 1-1.5% baking soda and 0.3% salt. In addition, we should avoid breeding in the hot season.
Premature sows: Summer delivery rooms should be well-ventilated and have a shaving facility. The sows reduce the concentrate 2-3 days before the birth, and feed the green material. The proportion of bran in the concentrate should be increased to prevent constipation and prevent dystocia. After the production, the bran and warm saline were fed once.
Commodity big pigs: It is difficult to raise in the hot season, often there is a trough, no food, affecting growth. Generally, fat pigs should be sold before the hot season is over. If not, the stocking density should be reduced. Spray water to cool, feed in the morning and evening, add green or thinner at noon, add 1.5% baking soda and 0.3% salt.
Suckling piglets and piglets: Hi-sleep on the wet ground, pay attention to the weather changes to prevent the cold pull or diarrhea. Keep the ring surface dry for clean drinking water and disinfect. Prevention can be applied for 120 days per kilogram of oxytetracycline for a few days, and 200 mg of oxytetracycline per kilogram of treatment.
Heatstroke prevention: First, move the pig to a cool and ventilated place and spray the whole body with cold water after drying, cut the ear and cut the blood, and take medication at the same time.
Shaft Collar
Shaft Collars are common pieces of hardware used for holding bearings and sprockets to shafts, situate components in motor and gearbox assemblies, and serve as mechanical stops. Shaft collars can be found in virtually any type of machinery and are frequently accessories to other components. Shaft collars provide three primary functions: 1) holding components in place, 2) locating or positioning components on a shaft, and 3) creating an attachment between shaft and another component. Despite their simple design, shaft collars play an important role in a wide range of industrial applications.
Yokelink Shaft Collars come in both inch and metric sizes and are available in either Carbon steel or 304 Stainless Steel. Yokelink shaft collars includes set-screw collars as well as one-piece (single-split) and two-piece (double-split) collars with zinc plated or black oxide finish. Our shaft collars are available for most common sizes ranging from 3/16″ to 4″ and 5mm to 100mm. When you need Shaft Collars, refer to our catalog, we offer them in a full selection of sizes, provide the diameter or part number to get a quote on these shaft collars, leave your message, or send us an email. You can also call us to get answers to your questions and place your order.
Shaft Collars,Zinc Plating Shaft Collars, set-screw collars, single-split Shaft Collar
Ningbo Yokelink Machinery Co.,Limited , https://www.yokelink.com